No Products in the Cart
Holes or other damage in textured walls can occur over time must be repaired. Matching the existing texture is critical to achieving a professional, flawless finish. Homax® makes small textured wall repairs easier with our texture repair tools.
Homax Wall & Ceiling Touch Up Sprayer comes complete with a small amount of both wall & ceiling texture. It’s great for small patch and repair work, or handy to keep in your home repair arsenal. The reusable hand-operated sprayer is perfect for small repairs to damaged textured walls. The non-aerosol sprayer adjusts to disperse a variety of interior texture patterns including orange peel, splatter and knockdown and popcorn ceiling texture. This handy repair kit also includes a knockdown knife for “knocking down” texture and a stir stick.
Kit Includes:
Where To Use
Homax Wall & Ceiling Touch Up Sprayer can be used to repair walls or ceilings. The sprayer adjusts for orange peel, splatter, knockdown, and "popcorn" ceiling textures.
Coverage
PREP:
Make any necessary wall or ceiling repairs prior to applying texture.
Ceiling stains should be sealed with a white, oil-based primer. Cover surrounding area to protect from overspray. Eye protection is recommended.
STEPS:
APPLICATION:
Wall Texture Repair: Select pattern by rotating applicator to desired position. Test spray pattern on cardboard or scrap drywall. Stand 1-2 feet from surface, pump to apply texture using short rapid strokes. Rotate applicator to OFF position when not spraying to prevent dripping.
Orange Peel Textures: Use the FINE or MEDIUM setting.
Knockdown Texture: Use the HEAVY setting.
After applying Orange Peel Heavy, allow material to begin to set up (5-10 min.), then use the plastic mud knife, flatten or lightly “knockdown” the texture to match the surrounding area.
Popcorn Ceiling Texture Repair: Point nozzle upright to ceiling and rotate pump to HEAVY setting. Hold pump at a 40° angle, and approx. 6-12" from ceiling. Pump using short rapid strokes. Rotate applicator to OFF position when not spraying to prevent dripping.
If desired texture pattern is not achieved, texture can be scraped off while still wet and reapplied.
CLEAN UP: Using warm water clean-up any over spray and tools.
TROUBLESHOOTING: If the material does not spray out, make sure nozzle is clear. Shake to free material. A very small amount of water may be added. If the material drips from the nozzle, close nozzle by rotating to the OFF position.
CAUTION! Wall Texture Contains: Calcium Carbonate, Talc, Silica, and Kaolin. Ceiling Texture Contains: Limestone, Kaolin, Attapulgite, Perlite, and Silica. Use with adequate ventilation during mixing and spray application. Do not breathe dust or spray mist. Avoid contact with eyes and prolonged contact with skin. Wear safety glasses or goggles and gloves.
If properly used, a respirator may offer additional protection. Follow respirator anufacturer’s directions for proper use. Wash hands after using.
FIRST AID: If inhaled, move to fresh air and get medical attention. In case of eye contact, immediately flush eyes with water for 15 minutes. Seek medical attention if irritation persists. If on skin, wash thoroughly with soap and water.
KEEP OUT OF THE REACH OF CHILDREN. WARNING: Cancer - www.P65Warnings.ca.gov.
WARNING: If you scrap, sand or remove old paint, you may release lead dust. LEAD IS TOXIC. Contact the National Lead Information Hotline or 1-800-424-LEAD or log onto www.epa.gov/lead.